Forum Title: Finishing bath and shower modules
When finishing one piece bath and or shower units there are two schools of thought. #1-Run the rock only up to the edge of the mounting flange and prefill with setting type compound (hot mudd) then flat tape and finish with green lid. #2-Fur out the wall so drywall factory tapered edge sets squarely over the flange and screw heads within a maxium 1/4 of the unit and fill with 100% silicone mold resistant caulk. Which method is most common in your neck of the woods? And why would you favor one over the other? In So.Cal #1 is the most common or in other words why do we do method #1 when the factory recommends #2
Category: Drywall Post By: PEARL SCHWARTZ (Pittsburg, CA), 03/08/2018

For Homeowners & Businesses - Helpful Links, Reviews, Ratings, Consumer Guide

requestaquote Get Free Quotes callnow 888-506-9527